公司新聞
瀝青冷補料施工時需要注意的事項
來源:http://m.guixin.net.cn/ 日期:2022-07-22
瀝青冷補料的好處想必大家肯定都有了解過,那么瀝青冷補料使用時要注意的問題,或者使用后出現的現象有哪些呢?
Everyone must have known the benefits of asphalt cold patching, so what should be paid attention to when using asphalt cold patching, or what are the phenomena after use?
1、瀝青冷油坑槽的清理
1. Cleaning of asphalt cold oil pit
確定挖槽位置,四周銑刨或切縫后,將坑槽內的碎碎石屑、渣子清理干凈,廢渣的要見到固體堅固面無松散的沙子為止
Determine the position of the excavation, after milling or cutting the joints around, clean up the broken stone chips and slag in the pit, and the removal of the waste slag should be until there is no loose sand on the solid solid surface
2、冷補瀝青混合料涂刷界面劑(必要時)
2. Cold patching asphalt mixture painting interface agent (if necessary)
在清理好的坑槽四周及底部刷涂界面劑,注意涂刷均勻(高速公路及車流量大的交通路段修補時必須涂刷界面劑)
Brush the interface agent around and at the bottom of the cleaned pit and pay attention to the uniformity (the interface agent must be painted when repairing highways and traffic sections with large traffic flow)
3、冷補瀝青填滿坑槽
3. Cold patching asphalt to fill the pit
填料高出路面1.5cm左右,填滿后坑槽處應稍高于四周路面并呈弧形
The filler is about 1.5cm higher than the pavement. After filling, the center of the pit should be slightly higher than the surrounding pavement and in an arc
4、瀝青混合料的壓實
4. Compaction of asphalt mixture
根據實地修補面積的大小和深度,選擇適當?shù)膲簩嵐ぞ吆头椒ㄟM行壓實。如汽車輪胎壓實、人力夯(hang)、振動平板夯壓實、壓路機壓實。高等級公路修補時,修補區域的四周和邊角應保證充分地壓實。
According to the size and depth of the field repair area, select appropriate compaction tools and methods for compaction. Such as automobile tire compaction, manual compaction (hang), vibrating plate compaction, roller compaction. When repairing high-grade highways, the surrounding and corners of the repaired area shall be fully compacted.
5、瀝青冷補料通車
5. Asphalt cold patching is open to traffic
濟南瀝青料廠家提醒您,修補完的坑槽四周邊角一定要壓實,無松散現象??闪⒓赐ㄜ?/div>
Jinan asphalt manufacturer reminds you that the four surrounding corners of the repaired pit must be compacted without looseness. It can be opened to traffic immediately
坑槽修補后,立即開放交通,車輛行駛后,坑槽表面會出現車轍,冷補料只要不會被車輪胎帶走,就不用處理,這是正?,F(xiàn)象,您可以放心使用,更多內容就來網站http://m.guixin.net.cn咨詢吧。
After the pit is repaired, the traffic will be opened immediately. After the vehicle runs, the pit surface will appear ruts. As long as the cold patching material will not be taken away by the car tire, it does not need to be treated. This is a normal phenomenon. You can rest assured to use it. For more information, please visit the website http://m.guixin.net.cn Consult.